A forum for owners of Yamaha TTR250 trail and enduro bikes!

locky · Guru

Handlebars .

noeyedear · Senior Member

You can turn the throttle, so the cables are at the bottom, gives you a little more length.

petenz · Super Guru

Yes

locky · Guru

Thanks blokes, i have the original bars off my Tenere that i plan to fit.

petenz · Super Guru

petenz wrote:
Yes

I have 30mm risers & CR high bend fat bars with the standard cables..

I got a longer clutch & throttle cables from Brian but didn't need them...

Pete

.

-- Edited by petenz on Friday 5th of December 2014 11:32:55 PM

locky · Guru

Thanks Pete. Whats the bike in your avatar ? European 1980's ?

petenz · Super Guru

locky wrote:
Thanks Pete. Whats the bike in your avatar ? European 1980's ?

1979/80 Montesa H6 125 Enduro..

also have a 1977 Montesa Cota 348 Malcom Ratnell Replica trials bike

locky · Guru

Can you post a bigger pic of them, i'd like to see them :)

Serial · Veteran Member

I wanna ask something

i dont have the original bar mounts...i dont even have the original handlebar (i have a odo fatbar)

but i sure feel awkward when standing...i have to lean forward and its annoying for my back...

im looking for risers....

will these ones -Bar "spacer" risers 6mm- do the job for me?

wiil they fit?

some pics of aftermarket handlebar and mounts

ttr cut.jpg

TTRfan · Super Guru

Hi Serial

I guess you are looking at these.

You need to have about 6mm of free thread underneath the yoke so that the existing security nuts will fit properly.

You can see what I mean in the following photo where a 6mm spacer has been fitted on the right.

It may be that the 6mm will not be enough of a raise to make you comfortable.

Brian

Serial · Veteran Member

Thanks Brian thats exactly the set i mean,

I have certainly some room under there so ill measure the screw and see what I do ...

bending over, that i forced to have forward is relatively small,so i think the 6mm risers will be enough to bring the handlebar where I want..i just need that click up..

BM Steve · Guru

Here's the risers I got from Brian some time ago, I'm 188cm tall so there a good fit, I'm going to machine 2 x 6mm discs to put underneath the clamps as well

I got new cables from Brian as well, they worked well together