A forum for owners of Yamaha TTR250 trail and enduro bikes!

Members Login
Username 
 
Password 
    Remember Me  
Post Info TOPIC: riding position


Veteran Member

Status: Offline
Posts: 31
Date:
riding position
Permalink  
 


i have a oe and i am finding the riding position when standing very cramped when i am balanced with a bit of bend at the knees and just the balls of the feet on the pegs the bars are virtually below my head so any acceleration or deceleration puts a fair amount of strain on the arms i have bar risers fitted which if anything make it worse because the angle of the clamp is rearwards so looks like the pegs need to moved rearwards a 2 or 3 inches anyone done this or even felt the need maybe the bike was never intended for much standing in the first place in which case different bike might be the answer which would be a shame as i have almost completely rebuilt it as steve would attest to with the number of orders i`ve placed   john



__________________


Super Guru

Status: Offline
Posts: 1481
Date:
Permalink  
 

I ride sIt to get down as I have a dodgy leg from a car trying to remove it. Works kind of OK but I can't feel it biggrin

I have seen my ttr ridden standing by family and mates with out problems 

The little I do try standing I find the one thing a lot of people do by mistake is stand with straight legs.  The idea of standing is to keep your knees bent to add to the suspension travel and allow you to move your weight Around 

 



__________________


Super Guru

Status: Offline
Posts: 1385
Date:
Permalink  
 

You could try rotating the bars forwards a bit. How tall are the risers?
Are you excessively tall?

__________________


Senior Member

Status: Offline
Posts: 484
Date:
Permalink  
 

I find mine very comfy standing, but I have higher bars and risers. if anything I find it a bit cramped sitting! I think its a personal set up, thing everyone's different. get the right rise and sweep on the handlebars for you.

__________________


Senior Member

Status: Offline
Posts: 143
Date:
Permalink  
 

Try Renthal Dakar high bars and leave them swept forward a bit .Great for standing if your a bit tall.

__________________


Veteran Member

Status: Offline
Posts: 31
Date:
Permalink  
 

thanks for the replies i see no one advocates moving the pegs i am 6foot 2inches tall i do ride knees well bent i just seem to be to near the bars so the will try the dakar high bars sounds could do the trick will i need longer cables etc. john

__________________


Senior Member

Status: Offline
Posts: 407
Date:
Permalink  
 

Hi john, I'm also 6ft 2 and have Dakars with bar risers too. Once you get that set up and nice wide pegs standing is peftectly fine. I've reduced how high the bars are though to 15mm as it made it easier to get in the van. Hope that helps

__________________

Thanks

Daniel Lee



Veteran Member

Status: Offline
Posts: 31
Date:
Permalink  
 

cheers for that will get an order in plus longer cables

__________________


Senior Member

Status: Offline
Posts: 143
Date:
Permalink  
 

I didn't need any cables but I think I routed them different.

__________________


Veteran Member

Status: Offline
Posts: 31
Date:
Permalink  
 

further to my problem i realised that when i go laning or ldt i tend to have a fairly weighty rucksack as the ttr at present has no capacity to carry luggage, when i rode it just down the lane from my house without the sack on my back i could balance a fair bit further back from the bars so will construct some luggage carrying frames so as to free up the load i currently carry john

__________________


Super Guru

Status: Offline
Posts: 8565
Date:
Permalink  
 

When I used to ride with a rucksack, I used to loosen the straps so that the weight of it was taken by the seat.

I later discovered the Wolfman Enduro tank and front mudguard bags and, together with fitting a rear mudguard bag on the headlight, I no longer carry anything that doesn't fit into my jacket pockets wink

Brian



__________________

Exeter, Devon, UK

http://www.ttr250.com  - The one and only dedicated TTR250 FAQ! 
 

TIP: For easy viewing bookmark the "Recent Posts" view - http://ttr250.activeboard.com/p/recent/ 

Page 1 of 1  sorted by
 
Quick Reply

Please log in to post quick replies.



Create your own FREE Forum
Report Abuse
Powered by ActiveBoard