I spend the day yesterday replacing the bearings in the front and rear wheels, which apart from a few rusted spacers all went ok. I then moved onto the swinging arm š«.
Ā 3 hours of hitting, heatingĀ and screaming and finally the bearings were removed. I then tried to gently knock one bearing in and all the needles fell out as I damaged the wall of the bearing. Anyways I have sourced a new bearing and don't want to make the same mistake again.
Ā I have read Brian's guide to fitting where he uses a threaded bar and washers but I was after anymore tips to make this a easier process.
