A forum for owners of Yamaha TTR250 trail and enduro bikes!

Members Login
Username 
 
Password 
    Remember Me  
The TTR250 FAQ web pages -> TTR250 -> Repairs and maintenance -> where's this come from?
Post Info TOPIC: where's this come from?
Kenny R


Veteran Member

Status: Offline
Posts: 46
Date:
where's this come from?
Permalink  
 

Over the last few days I have stripped and cleaned the lockable fuel cap, carburettor and yesterday was working on the air-box.

All done on the bench in the garage.

Dropped a screwdriver on the floor and when picking it up seen this rubber O ring laughing at me from the floor.

Hello there little O ring, I said, where have you come from??   No reply!!

Anybody know where it lives?



__________________
TT-R250M


Super Guru

Status: Offline
Posts: 1324
Date:
Permalink  
 

Hmm, tricky! confuse

I am going out on a limb to say it is from the locking fuel cap.

ttr etc 008.JPG

See here for more info- http://ttr250.activeboard.com/t51137706/locking-fuel-cap-key-barrel-removal/

It can't be the carburettor as none of the O-rings are 9mm.

The intake/airbox doesn't have O-rings other than the carb stub (which is not 9mm).

Jarrah



__________________

2000 TT-R250M-

Spoiler
Kenny R


Veteran Member

Status: Offline
Posts: 46
Date:
Permalink  
 

Not the fuel cap, had a look this morning and it is much smaller than the fuel cap O ring.

Don,t think it belongs the carb anywhere, and can't think of anywhere on the engine for one so small. 



-- Edited by Kenny R on Thursday 31st of October 2013 12:55:31 PM

__________________
TTRfan


Super Guru

Status: Offline
Posts: 8565
Date:
Permalink  
 

Athena_complete_gasket_set1.jpg

The pic above is of a very comprehensive Athena gasket set. Do you think it could be any of the O rings shown?

Or in the pic below?

Gasket Set 3.jpg

Brian



-- Edited by TTRfan on Thursday 31st of October 2013 01:32:56 PM

__________________

Exeter, Devon, UK

http://www.ttr250.com  - The one and only dedicated TTR250 FAQ!  

TIP: For easy viewing bookmark the "Recent Posts" view - http://ttr250.activeboard.com/p/recent/ 
TTRfan


Super Guru

Status: Offline
Posts: 8565
Date:
Permalink  
 

Bugeye_bob wrote:

what is M for in the picture ?

 Oil filler cap

K is the generator cover plug O ring

 



__________________

Exeter, Devon, UK

http://www.ttr250.com  - The one and only dedicated TTR250 FAQ!  

TIP: For easy viewing bookmark the "Recent Posts" view - http://ttr250.activeboard.com/p/recent/ 
TTRfan


Super Guru

Status: Offline
Posts: 8565
Date:
Permalink  
 

It's got me foxed Kenny confuse



__________________

Exeter, Devon, UK

http://www.ttr250.com  - The one and only dedicated TTR250 FAQ!  

TIP: For easy viewing bookmark the "Recent Posts" view - http://ttr250.activeboard.com/p/recent/ 
Bugeye_bob


Veteran Member

Status: Offline
Posts: 53
Date:
Permalink  
 

www.cmsnl.com/yamaha-ttr250rrc-2003_model11181/partslist/B-02.html

part 28 on this ?

__________________
Kenny R


Veteran Member

Status: Offline
Posts: 46
Date:
Permalink  
 

No not there either, that's a large square section rubber O ring under that plate.

Ta.cry



__________________
Kenny R


Veteran Member

Status: Offline
Posts: 46
Date:
Permalink  
 

Think I'll throw it back on the floor and pretend I never seen it.....



-- Edited by Kenny R on Thursday 31st of October 2013 08:15:44 PM

__________________
Bugeye_bob


Veteran Member

Status: Offline
Posts: 53
Date:
Permalink  
 

what is M for in the picture ?

__________________
Kenny R


Veteran Member

Status: Offline
Posts: 46
Date:
Permalink  
 

What's the small one below the two lighter coloured gaskets that look like exhaust gaskets in the bottom set?

__________________
TTRfan


Super Guru

Status: Offline
Posts: 8565
Date:
Permalink  
 

Kenny R wrote:

What's the small one below the two lighter coloured gaskets that look like exhaust gaskets in the bottom set?

Oil filter - not sure why only one in the pic though!

 

Item No.O.E.M. No.Itemsq'ty/set
14GY-11181-01GASKET CYLINDER HEAD 11
24GY-11351-00GASKET CYLINDER 1
34GY-11193-00GASKET HEAD COVER 11
44FM-12213-00GASKET TENSIDNE CASE1
593210-78544ORING1
633M-12119-00SEAL VALVE STEM4
74FM-14613-00GASKET EXHAUST PIPE1
    
84GY-13329-00GASKET PUMP COVER 1
94GY-15451-00GASKET CRANKCASE COVER 11
104GY-15461-00GASKET CRANKCASE COVER 21
1193210-54175ORING - Oil filter cover -  large O ring1
1293210-07135ORING - small O rings on filtercover2
1393210-10096ORING - copper banjo washers1
1493210-40659ORING - carb inlet stub1
1593210-32172ORING - bung on crankcase cover1
1693210-14369ORING - bung on crankcase cover1
1793210-19123ORING - copper washer on oil check screw1
1893210-74M68-00ORING(93210-74424/93210-74M35-00) - starter cover O ring1


__________________

Exeter, Devon, UK

http://www.ttr250.com  - The one and only dedicated TTR250 FAQ!  

TIP: For easy viewing bookmark the "Recent Posts" view - http://ttr250.activeboard.com/p/recent/ 
TTRfan


Super Guru

Status: Offline
Posts: 8565
Date:
Permalink  
 

Kenny R wrote:

Think I'll throw it back on the floor and pretend I never seen it.....

biggrinbiggrin 



__________________

Exeter, Devon, UK

http://www.ttr250.com  - The one and only dedicated TTR250 FAQ!  

TIP: For easy viewing bookmark the "Recent Posts" view - http://ttr250.activeboard.com/p/recent/ 
TT-R250M


Super Guru

Status: Offline
Posts: 1324
Date:
Permalink  
 

Kenny R wrote:

Think I'll throw it back on the floor and pretend I never seen it.....



 

 That is the best idea, it probably is not from your TTR250 anyway biggrin



__________________

2000 TT-R250M-

Spoiler
Page 1 of 1  sorted by
 
Quick Reply

Please log in to post quick replies.
The TTR250 FAQ web pages -> TTR250 -> Repairs and maintenance -> where's this come from?


Create your own FREE Forum
Report Abuse 		Powered by ActiveBoard