I have had some cold starting problems on my 325 whereby it starts but quickly dies.
I raised the pilot jet size up from 48 to 50 and it seemed to make an improvement but I haven't run the TTR often enough to test it thoroughly.
I came across this video this morning and, even though the guy is dealing with a TTR125, I recognised the poor cold starting symptoms.
I looked at a dismantled TTR250 carb and, sure enough, there is a small jet in the float bowl that meters fuel to the brass choke tube and hence the choke itself. I had not realised it was there Every day is a school day
I checked the circuit on my own carb and think I may have cleared a partial blockage but I will need to get the carb back on to check.
But, irrespective of whether I fixed my carb, it is a useful tip to any other owner stripping and cleaning their carb to check this circuit is clear.
Haven't had this issue with 250, still good to know, but I never thought about this on the 125, golden! Cold start and idle problems are common on the 125 I always just go to the pilot jet (on my third pilot jet cause they don't clean well). Thanks Brian!
Good find Brian! Youtube - home of video wonders. I suppose a bigger pilot would have similar effect when cold - putting more fuel in instead of the choke circuit, but then when warmed up, the pilot is bigger than necessary.
OK - so I cleaned the newly discovered jet in the float bowl, put back the 48 pilot jet (and fitted a new diaphragm and O rings as the rubber on the old diaphragm had "died" and was virtually solid) and gave it a try.
Choke fully out and it started first time, but, this time kept running without the usual cough/stall business! I am well pleased to have fixed this irritation
The power of Facebook (where I found the tip and link) and YouTube combined eh?