A forum for owners of Yamaha TTR250 trail and enduro bikes!

TTRfan · Super Guru

Wanted - hub for rear wheel

pug · Guru

Hi

is there meat in the hub to turn a bit out an put a bush into it on the lathe it only need's about 2mm od taken out to make one up

pug

TTRfan · Super Guru

Hi pug

I had thought of doing something similar but assumed it would be very expensive. Do you know what it might cost to do that work please?

The hub is all stripped out now and was going to be thrown away.

Brian

pug · Guru

It's a one or two hour job for a man with a lathe like most thing's you would be looking at £30 -£40 pound a hour at most workshops you want a man with a lathe in his shed who will do it for a tenner. i have the shed out back of the house with a lathe in it but im eye ball deep time wise for two weeks but hay ho if you drop it round with the center spacer an new bearings an i will see what i can do. i will email you me number if you are in no rush an want me to have a look. [ it's the worse time of the year for me all the last one off bit's an bob's people wanting to finish off there winter re-builds]

pug