A forum for owners of Yamaha TTR250 trail and enduro bikes!

Just finished a new tail tidy

Stated out as a 100mm x 100mm x 1.6mm flat sheet

Then mark out and drill in the appropriate places

Put an Rubber Grommet in to protect the cable

Bend it in a vise to about 80Deg

Use the standard TTR tail light, add abit of foam to help keep the dust and dirt out

Assembled, front view, Aussie Number plates are way smaller than the UK ones as you see

Rear View, If you look closely I put some Clear tubing on the remaining threads to keep them clean, easier to remove the nuts if need be.

Used the standard mounting point and drilled and added an extra bolt to stop it moving, you could use a self driller as well, I did at first but replaced it with a gal bolt

Another Side View

All Done, and tidy, out of the way and provides a bit more flying mud protection