A forum for owners of Yamaha TTR250 trail and enduro bikes!

Members Login
Username 
 
Password 
    Remember Me  
Post Info TOPIC: Please Help 06' ttr 250 Not starting


Senior Member

Status: Offline
Posts: 117
Date:
Please Help 06' ttr 250 Not starting
Permalink  
 


have a look on youtube at these links its a local Australian motorbike show that did an article on what to do when pulling a bike out of storage

http://www.youtube.com/watch?v=KC6fIoUmO-o  (part1)
http://www.youtube.com/watch?v=a8ngSDq8gnk&feature=related  (part 2)


but i think you have done most or more of the things they suggest.


-have you checked your choke (starter plunger) is not bent or damaged?
-is the starter jet clogged (its in a slightly different are to main jet i think)
-when you reinstalled the carb did you put the plunger in the correct way round (i have done it incorrectly and the engine wouldn't start for me!)
- is your pilot screw set way way wrong
-have you checked there is actually a spark coming from the spark plug? (if not then you can go onto check all kinds of electrical things eg, stand switch, neutral switch, kill switch, pick up coil ect)
-is there oil in the engine?

if you download the ttr250 work shop manual it has a whole section on this but iv included the 2 pages on that stuff below hopefully it works.

good luck



Attachments
__________________
A dried up puddle is a missed opitunity ;) Melbourne Australia


Newbie

Status: Offline
Posts: 4
Date:
Permalink  
 

Ok so first i should say hello as this is my first post and i will thank you all for any help in advance. The Run Down: I have a 2006 ttr 250 that has been sitting in the garage for about a year without being started cry. I knew that i was going to have some issues when trying to get it back running. I emptied the gas tank and replaced with clean fuel. I replaced spark plug and pulled carb out to clean jets and other componets. I put a new air filter on it because it wouldnt hurt and needed it anyway. My initial thought was that it had to be something with the carb having the dirty gas sit in it but even after cleaning it out and cleaning jets i am having no luck getting it started. I am sure that there have been similar issues from other members but i havnt been able to find anything that is working. Should i replace jets? or anyother ideas you may have will be greatly appreciated. Thanks againg in advance. Oh yea, not sure if it makes a huge difference but it was not idling great the last time that i did ride the bike if that changes anything, also this bike is practically brand new. I bought it new in 2006 and maybe rode it ten times so i dont think it would have any serious motor issues but then again im not a mechanic.



__________________


Newbie

Status: Offline
Posts: 4
Date:
Permalink  
 

Yea I have checked for good spark and all of my other electrical components are working fine. I'm at a loss not being able to get it started after doing all the normal steps. Pilot screw is good and oil will need to be changed once I get it running. I have the manual and have tried the things I can do my self but still no luck


__________________


Super Guru

Status: Offline
Posts: 2610
Date:
Permalink  
 

We've had this problem crop up a few times in the past. confuse

It was solved for for  Vancor88 - take a look here CLICKY THINGY

There have been various things wrong but mostly it turns out to be one of the carb jets being slightly blocked (if not wholly blocked).

Good luck. wink

BTW - welcome to the forum, Jeff.

Martyn



__________________

You're never too old to learn something stupid

East Budleigh. Devon



Veteran Member

Status: Offline
Posts: 82
Date:
Permalink  
 

take the plug out, squirt a half dozen drips in the plug hole, put the plug back in, cap on see if it fires at all if it starts a bit or fires up the problem is the carb. did you tear EVERY last jet out of the carb and blow out every hole orifice? if not try that also is the plug new and gapped correctly? is the plug wire ok? is the plug cap ok?
Ping if you need help diagnosing it


good luck!


Matt

__________________

Matteo

I'd give my right arm to be ambidextrous...



Newbie

Status: Offline
Posts: 4
Date:
Permalink  
 

Yes I put a new plug in it and gapped it correctly. I am going to pull the Carb out again when I get a day off and clean and blow everything out again. I hate to sound stupid for a lack of better term but squirt a half dozens drips of what in the spark plug whole?


__________________


Veteran Member

Status: Offline
Posts: 82
Date:
Permalink  
 

I was the stupid one.... I write faster than I think sometimes lol ...... gasoline.... not too much or it will flood

 

 

Matt



__________________

Matteo

I'd give my right arm to be ambidextrous...



Newbie

Status: Offline
Posts: 4
Date:
Permalink  
 

its amazing what the internet and a few of the good people left in the world willing to help another rider can do. I got my baby to start so I'm am grining from ear to ear. It is not running great and I need to replace the pet**** since I can't get a good flow of gas to keep it running but just hearing it made my day and saved my wallet doing it myself. Hopefully the pet**** will straighten out the rest of the issues and maybe a little tweaking of other things. You guys are awesome and thanks for all your help and input!

__________________
Page 1 of 1  sorted by
 
Quick Reply

Please log in to post quick replies.



Create your own FREE Forum
Report Abuse
Powered by ActiveBoard