A forum for owners of Yamaha TTR250 trail and enduro bikes!

Members Login
Post Info TOPIC: Sprag clutch issues - checklist


Super Guru

Status: Offline
Posts: 6539
Date:
Sprag clutch issues - checklist
Permalink  
 


Starter clutch.jpg

 

If you are going to the expense or replacing the starter clutch (#10 in the fiche pic above) there are a few things to check to make sure your investment pays off:

  1. Make sure that the boss on the large starter gear #7 (the sprag depends on this one to work properly) in good condition, not worn and with no pitting, scoring, ridges or other damage that might prevent the sprag doing its job.
  2. All the teeth on starter gears #7, #4 and #1 should be in perfect “sharp” condition with no rounding, burrs, roughness, wear or chips on the teeth. In particular, gear #1 has to be perfect.
  3. Check the bearings #2, #5 and #9 are all OK along with their housings and, in particular the housing in the starter gear cover for bearing shaft #3. There shouldn't be any movement that would allow the gears to misalign.
  4. Check the generator cover isn't cracked or damaged in some way that would allow movement of the gears and consequent meshing problems. A tell-tale sign of a cracked cover is an oil leak from around the starter gear cover area.

All the parts are available new here

Brian

 



__________________

Exeter, Devon, UK

http://www.ttr250.com  - The one and only dedicated TTR250 FAQ! 
 

http://ttr250.activeboard.com/ - THE forum for TTR250 owners

Page 1 of 1  sorted by
 
Quick Reply

Please log in to post quick replies.



Create your own FREE Forum
Report Abuse
Powered by ActiveBoard